LBW2000PB Vertical Glass washing and drying machine
 

Operate:
The machine has glass feed part, glass washing and drying section, light inspection part.
2. The first area is outfitted with LOW-E glass verify system. When the coated side is wrongly place, the technique will give alarm and the express will stop routinely.
three.3 pairs of brushes driven independently by 3 motors. Brushes thread are imported comfortable content, particular for LOW-E glass.
four. Washing segment uses SKF model oil-cost-free and water-evidence bearings. It will not trigger 2nd contamination to glass.
5. Static electrical energy get rid of system is geared up at the finish of washing part. It can remove the static electric power of the glass so the dust will not tumble on the glass.
six. Washing velocity is managed by an inverter.
 
Secotion1: Feed Part:
 
The back board is substantial density board with movie
  It is the first part of the line and its main function is to transmit the glass to the washing and drying segment. The transmission is carried out by chains driven by the motor and the transmission velocity is stable. It runs at the same pace of the washing and drying area and the velocity can be modified by the inverter. It can keep away from the again board bending and deformation, also can watertight, avoid acid-foundation.
 

 LOW-E glass computerized diagnosis technique: it can effortlessly know whether or not minimal-E glass putting is proper or not. When is incorrect, the alarm will increase the alarm, and worker can alter it instantly. 
 
Section2:Washing and Drying Section:
Washing component:
  This part has 3 pairs of brushes (the substance is substantial -temperature nylon wire ) and a pair of sponge roller. The brushes are pushed by 3 synchronous motors individually and the motion is stable. Three pairs of tubular rollers type of hair brushes, use Substantial Temperature Resistant and delicate nature hair brush, completely certain the coating glass particularly the Reduced-E glass layer stratification can not be destroyed. 
one. It adopts custom made-produced and imported nylon, front is a few pairs of comfortable brushes (Φ0.07mm), back again is a few pairs of hard brushes (φ0.10mm),it last the brushes daily life.
two. According to the glass thickness, immediately management the spacing of the drag roller, it doesn’t want any other handbook adjustment for the glass that have different thickness in the adjustable scope by bearings.

Drying component: the air enters into the air knife from the prime. The length among the air knife and the glass must be adjusted in accordance to the thickness of the glass in purchase to ensure the drying influence. Air passage adopts the most sophisticated layout and boost the drying speed and efficiency.
one. There is a pair of rhombic air knife, the front air knife can change backward or CZPT in accordance the glass thickness. The blower, which is outfitted with heater, blows robust scorching wind also it is equipped with infrared heater that can dry the the two sides of the glass quickly.
2. The dry section employs the large quality stainless steel, all of them are anti-corrosive material (like air knife, transfer gantry).
 
Section3: Transition and Unloading Section:
   This part is utilised to transmit and retailer the glass to boost the operate efficiency Light inspection is outfitted with a foot switch. You can end the express and check the washing quality.
* Top opening and overturning system (tilting desk) is optional.

CZPT parameter:

Primary Components Brand

Welcome to go to our manufacturing facility!